KAMBUS Training

KAMBUS INC (219) 771-1742 kmartinsen@kambus.com

Training KAMBUS.COM

This is a brief description of roll grinder training

OPERATOR TRAINING TOPICS

1. Observe operators; how they grind. Make a training schedule to cover all crews.

2. Explanation of grinding terms, shape, taper, infeeds, etc

3. How a grinder differs from a lathe

4. How a roll grinder works mechanically.

5. How to load a roll, set up for grinding, trip limits.

6. Roll alignment

7. Touch off, short stroking.

8. Grinding steps; roughing, semi finishing, finishing.

9. Continuous infeed, step infeed, load control.

10. Correcting shape, taper

Maintenance Training Topics

1. Explanation of grinding terms, shape, taper, infeeds, etc

2. How a grinder differs from a lathe

3. How a roll grinder works mechanically.

4. Block diagram of electrics

5. PLC debuging, loading program.

6. MMI

7. Motor Drives, tuning, diagnostics

RGB Crowner Training

1. Crowner operation, run and setup screen

2. Infeeds, step and end infeed

3. Block diagram

4. Servo drive

5. FFP, how to make custom shapes

PLC Training is also available

[ Home ] [ Up ]